Here’s how you can attach a flag to a flagpole

You have finally purchased a flagpole, and you have the flag ready with you too. However, you are confused and don’t know how to attach a flag to a flagpole. If this is the reason why you are here, then you have come to the right place. Whether you have a commercial flagpole or a residential flagpole, you will not like it to remain empty. So, read this blog and know from us how you can easily attach a flag to a flagpole.

Utilizing Cable Ties - (For banners/pennants with grommets (open air or indoor use with post)) Simply place a link tie through the grommet and secure onto the flagpole.

Snap Hooks

(For banners/flags with grommets (open air use with rope)) Determine where to introduce the snap snares:

1. For another banner: Measure the separation between the grommets on your banner. This will be a similar separation between the snap snares on the rope.

2. Supplanting old snap snares: First, ensure any bunches or other rope imperfections that would keep the rope from stringing through the pulley are at the base of the rope circle and the snap snares are near the top. Lower the banner and put the new snap snares in roughly a similar area as the old snap snares.

At that point, string the snap snares:

1.Slip a circle through the eye of the snap snare. ◦Put the circle over the highest point of the snap snare and draw rope tight.

Tabs

(For banners/flags with shaft sew and sewn-in tab (indoor or outside use)) Slide post however sleeve of standard and push precut eye through the leader of the metal screw.

E-Z Mount

1. Unscrew plastic screw from EZ-Mount ring.

2. Slide ring onto flagpole.

3. String plastic screw through the banner's grommets and screw once again into EZ-Mount ring.

Velcro

(For banners/flags with post trim and velcro (indoor introduction use)) Follow maker's directions.

1. Slide post however sleeve of pennant to view situating.

2. With the two bits of Velcro still joined, expel clingy once again from one side and spot on post in wanted position.

3. With the two bits of Velcro still joined and now connected to the post, expel the other clingy back, slide pennant sleeve up and into nearby position and press against the glue back.

4. Rehash ventures for the base of the shaft sleeve.

In case , you are still not able to do it on your own, then visit www.flagpolesetc.com and the experts help you.