Flags
are determined and recognized to display patriotism, national country respect,
national holidays, sports team representation, house decoration. So, to fly the
flag at home, it must be installed carefully because of its improperly placed,
it will not keep flying for long.
Flying
and installing flagpole on top of the
building is not a difficult job, but you have to ensure it has been
mounted properly with care and respect. Select the place to install flagpole
which does not affect your home building with any damage.
Below
are some few steps which must be followed to mount flagpole at home.
Things
needed while mounting flagpole on top of
the building. They are:
1.
Pencil or marker
2.
Driller for drilling a bit
3.
Caulk and Anchors
4.
Few screws of 1 to 1.25 inch
5.
Screwdriver to fit and tighten the screws
Steps
are described in detail below:
•
Mark positions
Decide the position of installing
flagpole. Tower
climbing Start with
marking the position to bracket where you are planning to mount your flagpole,
then mark it with marker or pencil where holes are supposed to be a dig.
•
Start drilling
Use
driller to drill the base which is made of bricks or wood makes holes deep up
to 1 to 1.25 inch same as the screw inches. If the Tower climbing
of the base of the flagpole is made of brick, assure you don’t drill in the
mortar, drill into the brick only. If it is wood, it is the best, no mortar
care is needed, but it might be there only if the building is recently made.
•
Holes caulking
Now,
start caulking in the holes you drilled to stay water outside.
•
Bracket
Combine
bracket or pole to the side or top of the building using 1 to 1.25 inch of
screws. Don’t use pole or bracket given with purchase of flag, use another pole
to keep it for a long time, else it will fall or damage your building or home
building. Also, remember in mind if you drill holes in brick, you must use
stainless or plastic screws for strong support.
•
Finally, place your flagpole
Hence,
you are done and see the fling flagpole with a flag.
No comments:
Post a Comment